e-zy.net

  

EZ3 +
Home / Outdoor / EZ-BridgeLT2-HD
Show a printable view of this document

content

search results
- Outdoor
EZ-Go-2
EZ-Go-5
EZ-Bridge-LT2
EZ-Bridge-LT5
EZ-BridgeLT2-HD
EZ-BridgeLT5-HD
EZ-Base
+ Indoor
+ Antennas
+ Accessories
+ Support
+ Calculations
News
About E-ZY.net
Warranty and RMA
Where to buy
Contact us

EZ-BridgeLT2-HD™

The EZ-BridgeLT2-HD™ is a high power 250mW outdoor wireless bridge system with built in Ethernet and AC Power surge protection for ultra reliable operation in harsh environments. The complete system comes with two 75' Shielded outdoor rated Cat5 cable assemblies to protect against EMI caused by lightning.

EZ-BridgeLT-HD

Compatibility :

The system operates in the 2.4GHz unlicensed frequency spectrum providing real world thruput up to 20 Mb/sec. It complies with the 802.11bg standard to insure interoperability. The EZ-BridgeLT2-HD™ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight. It supports multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. Multiple EZ-BridgeLT2-HD™ units can be connected in a mesh configuration to allow interconnecting more than two sites.

Security :

With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.

Installation :

Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power supplies. The units will automatically find their peer and create a secure wireless network link. If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer.

Package Contents :

The EZ-BridgeLT2-HD™ comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 14dBi 802.11bg antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Surge Protected 18V POE (Power Over Ethernet) power inserters and 75' Shielded Outdoor Rated CAT5 cable assemblies.

Additional Images :

Ez-BridgeLT-HD_Small EZ-Bridge-02 EZ-Bridge-03 EZ-Bridge-04

Additonal Information :
PDF icon Datasheet
PDF icon Quick Installation Guide
PDF icon User Guide
Firmware Icon Firmware
Tool Icon Utility
 
Package Contents :
2 x EZ-BridgeLT2-HD™
2 x Mounting Bracket
2 x 18v PoE Injector
2 x 75' Shielded CAT5 cables
1 x Quick Install Guide
 
Order Number :
EZBR-0214
 
Physical
Dimensions 410 x 350 x 110mm
(16.1" x 13.7" x 4.3")
Weight 2760gr (6lbs)
Radome ABS (UV resistant)
L-Bracket Galvanized Steel
U-Bolt Stainless Steel 1"-2"
 
System
Processor Realtek 8186
Speed 200MHz MIPS
Flash 2MB
SDRAM 16MB
Radio RTL8225
Power Amplifier SE2527
 
Antenna Pattern

EZ-BridgeLT-HD_Antenna_Patterns_Small

Pattern in JPG format

Pattern in PNG format